SL DigitaLink Remote Control Programming
Option 1
1. Please visit our website or refer to the directions below.
2. Enter or locate the make/model of the TV and you will find the correct code needed to program the remote.
3. Adjust TV volume to lowest setting manually or with TV remote.
4. Adjust the DigitaLink volume using the DigitaLink remote to maximum level on the volume bar.
5. Turn on your TV.
6. Press and hold Set until the red light on the remote blinks twice. Release Set.
7. Enter the code you received on-line. The red light on the remote will blink twice.
8. Press Set once to lock in the code. The red light on the remote will blink twice.
9. Press Power to turn your TV back on.
Option 2
1. Adjust TV volume to lowest setting manually or with TV remote.
2. Adjust the DigitaLink volume using the DigitaLink remote to maximum level on the volume bar.
3. Turn on your TV
4. Press and hold Set until the red light on the remote blinks twice. Release Set.
5. Enter 991. The red light on the remote will blink twice.
6. Point the remote at the TV and press CH+ repeatedly until the TV turns off.
7. Press Set once to lock in the code. The red light on the remote will blink twice.
8. Press Power to turn your TV back on.
| |
Note: If audio is not set in the correct sequence before programming the remote, there may be low or no audio. If this occurs use the following steps
|
1. Press and hold set until the red light blinks twice, release set.
2. Enter in 993 (The red light will blink twice after the three)
3. Press and release the digit 1 ( The red light will blink 4 times after the 1)
You can now go back and perform the above listed paring sequence
When programming the remote for some Magnavox TV sets, it may be necessary to press any other number on the remote control before pressing Power in order in order for the programming to work.